Portable Heat Gun Shrink Tube Heating Soldering Phone Repair DIY Craft 300W/110V

Description

Store Categories
Store Categories
Floor mat
XPE floor mat
TPE floor mat
Trunk mat
Dash mat
Cushion cover
Honda
Ford
Jeep
Mazda
Nissan
Toyota
Tesla
Chevy
Dodge
Other
Product Description
Description
This heat gun is not a High Power one due to its 300W low power. But it is great for heating shrinkable film, embossed powder, rubber stamp, the best choice to replace toaster or oven and the polymer clay will become hard and bright after using the gun.
Keeping 5-6cm distance from work and about a 45 degree angle to heat until it is completed.
After completion, use the heat gun at high temperature to blow a few seconds.
It not only can add its hardness, but also its brightness.
This kind of gun can not adjust the temperature but it heats up quickly at about 200℃ theoretically.
Therefore do not blow your Polymer Clay Works at one position for a long time to prevent distortion.
The hot air gun should not be used for a single time. If the temperature of the body is too high, please turn off the hot air blower and wait for the cooling to be used again.
Be careful when using the hot air gun.
Do not blow directly at a 90 degree angle
Specification
▪Color: Black
▪Material: ABS
▪Type: Constant temperature
▪Rated power: 300W
▪Rated voltage: 110v
▪Working time: 5 minutes
Payment Policy
Shipping Policy
Returns Policy
Payment Policy
Pay securely with any major credi
t card through PayPal！
Shipping Policy
All items will be shipped to buyer's ebay address. Before you pay, please make sure your address in ebay matches the address you would like us to ship to.We are not responsible for any wrong or undeliverable addresse
.
Returns Policy
Copyright © 2018 Dianxiaomi